Kia Sedona: Front Wheel Guard Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Body Side Moulding / Front Wheel Guard Repair procedures

Replacement

Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

1.	Remove the front tire.

2.	Remove the front mud guard. (Refer to Body Side Moulding - "Front Mud Guard")

3.	After loosening the mounting clips and screws, remove the front wheel guard (A).

Install in the reverse order of removal.

Replace any damaged clips.

Rear Spoiler Repair procedures

Replacement Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, an ...

Rear Wheel Guard Repair procedures

Replacement Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, an ...

Other Information:

Operating conditions
The indicator on the switch will illuminate when the Blind Spot Detection System (BSD) switch is pressed with the Engine Start/Stop Button ON. If vehicle speed exceeds 30 km/h (18.6 mph), the sys ...

Battery Sensor Repair procedures
Removal 1. Turn the ignition switch OFF. 2. Disconnect the battery negative (-) terminal (A). Battery negative (-) terminal tightening nut : 4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 3.0 ~ 4.4 lb-ft ...

Kia Sedona: Front Wheel Guard Repair procedures

Rear Spoiler Repair procedures

Rear Wheel Guard Repair procedures

Other Information:

Categories