Replacement |
1. |
Remove the front door module.
(Refer to Front Door - "Front Door Module") |
2. |
Remove the front door outside handle base (A) by pushing in the lock pins located in the back. |
3. |
Remove the front door outside handle cable (A). |
4. |
To remove the front door outside handle base connector (A), turn it counter clockwise and pull it forward. |
5. |
Remove the front door outside handle connector wiring harness (A). |
6. |
Disconnect the front door latch connector (A). |
7. |
Remove the front door latch assembly (B) by pulling it in the direction of the arrow. |
8. |
Disconnect the front door latch cage (A). |
9. |
Remove the front door inside handle cable (A) by pushing it backward. |
10. |
Install in the reverse order of removal.
|
Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).
4.
Me ...
Adjusting the height up and down
To raise the headrest, pull it up to the desired position (1). To lower the headrest,
push and hold the release button (2) on the headrest support and lower the headrest
to the desired position ...