Kia Sedona: Troubleshooting| Troubleshooting |
| Symptom | Suspect Area | Remedy (Refer to page) |
| Water leaks from panorama sunroof | Deteriorated roof lid weatherstrip | Replace |
| Excessive roof lid-to-body clearance and improperly fitted weatherstrip | Adjust | |
| Wind noise around panorama sunroof | Loose or deformed deflector, gaps in body work | Retighten, adjust or replace |
| Noise heard when opening/ closing panoramaroof | Foreign particles lodged in guide rail | Check drive cable and guide rails for foreign particles |
| Loose guide rails and lid | Retighten | |
| Motor runs but sunroof does not move or moves only partially | Foreign particles lodged in guide rail | Adjust or replace |
| Incorrect engagement of motor pinion with drive cable | ||
| Decrease in motor`s clutch slipping force | ||
| Increased
sunroof sliding resistance or interference of sunroof with drive
cables, weatherstrip, etc. due tomal adjustment of sunroof | ||
| Noise in motor (clutch slipping noise from motor when sunroof is fully opened or closed is not an unusual noise | Incorrect engagement of motor pinion with drive cable | Check pinion installation and |
| Re-tighten motor | ||
| Worn out or damaged motor pinion bearing | Replace motor assembly | |
| Worn out or deformed drive cable | Replace | |
| Door glass fails to operate up and down | Incorrect window glass installation | Adjust position |
| Damaged or faulty regulator arm or regulator | Correct or replace | |
| Door does not open or close completely | Incorrect door installation | Adjust position |
| Defective door check assembly | Correct or replace | |
| Door hinge requires grease | Apply grease | |
| Hood does not open or close completely | Striker and latch not properly aligned | Adjust |
| Incorrectly installed hood | Adjust | |
| Incorrect hood bumper height | Adjust | |
| Water leak through windshield end rear window | Defective seal | Fill with sealant |
| Defective flange | Correct |
Special Service Tools
FenderDriver's Attention
The driver must be cautious in the below situations for the system may not assist
the driver and may not work properly.
- Curved roads, tollgates, etc.
- The surrounding of the sensor is polluted ...
Intake Actuator Description and Operation
Description
The intake actuator is located at the blower unit. It
regulates the intake door by a signal from the control unit. Pressing
the intake selection switch will shift between recirculat ...