Kia Optima Manuals

Kia Sedona: Front Impact Sensor (FIS) Repair procedures - SRSCM - Restraint - Kia Sedona YP Service ManualKia Sedona: Front Impact Sensor (FIS) Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Repair procedures

Removal
   
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON nor connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable and wait for at least 30 seconds before beginning to work.
2.
Remove the front impact sensor mounting bolt (A).

3.
Disconnect the front impact sensor connector.
Installation
   
•
Do not turn the ignition switch ON nor connect the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting bolt.
Tightening torque :
6.8 ~ 9.2 N.m (0.7 ~ 0.94 kgf.m, 5.0 ~ 6.8 lb-ft)
3.
Connect the front impact sensor connector.
4.
Reconnect the battery negative cable.
5.
After installing the Front Impact Sensor, confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Front Impact Sensor (FIS) Components and Components Location
Components ...

Side Impact Sensor (SIS) Description and Operation
Description Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensors (P-SIS), installed at each center of front door modules (LH and RH), two SIS, installed at each center o ...

Other Information:

Front Door Trim Repair procedures
Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protec ...

Heating and air conditioning
1. Start the engine. 2. Set the mode to the desired position. For improving the effectiveness of heating and cooling; - Heating: - Cooling: 3. Set the temperature control to the desired positi ...

Categories

Copyright © www.kisedona.com 2016-2026