Component Replacement After Deployment |
Before performing any SRS repairs, use the GDS to check for
DTCs. Refer to the Diagnostic Trouble Code list for repairing related
DTCs. |
– |
SRSCM |
– |
Deployed airbag(s) |
– |
Seat belt pretensioner(s) |
– |
Front impact sensors |
– |
SRS wiring harnesses |
– |
Inpsect the clock spring for heat damage.
If any damage is found, replace the clock spring.
|
– |
SRSCM |
– |
Deployed airbag(s) |
– |
Side impact sensor(s) for the deployed side(s) |
– |
SRS wiring harnesses
|
– |
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off. |
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).
4.
Me ...
Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the
turn signals, move the lever up or down (A). The green arrow indicators on the instrument
panel indicate which tur ...