Kia Sedona: BJ Boot Components and Components Location

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Components and Components Location

Dynamic Damper Repair procedures

Removal 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint”) 3. Remo ...

BJ Boot Repair procedures

Removal 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint”) 3. Rem ...

Other Information:

Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV terminals 1 and 2. 4. Check that the resistance is within the speci ...

Ignition Coil Repair procedures
Removal Ignition coil (Cylinder #1) [Bank 1] 1. Remove the surge tank. (Refer to Engine Mechanical System - "Surge Tank") 2. Disconnect the Ignition coil connector (A). 3. Remove the i ...