Kia Optima Manuals

Kia Sedona: Dynamic Damper Repair procedures - Driveshaft Assembly - Driveshaft and axle - Kia Sedona YP Service ManualKia Sedona: Dynamic Damper Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Repair procedures

Removal
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”)
3.
Remove the remove the both side of band (B) of the dynamic damper (A).

4.
Fix the driveshaft (A) with a vice (B) as illustrated.

5.
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper when the dynamic damper is removed.
6.
Seperate the dynamic damper (A) from the shaft (B) carefully.

Installation
1.
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
3.
Install the dynamic damper band (A).
4.
Using the SST(09495-3K000), secure the TJ boot bands (B).
Clearance (A) : 2.0 mm (0.0787 in.) or less

5.
Install the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ joint”)
6.
Install the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
7.
Check the front alignment.
(Refer to Suspension System - "Front Alignment")
Dynamic Damper Components and Components Location
Components 1. BJ assembly2. BJ circlip3. BJ boot band4. BJ boot5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. Retainer ring12. TJ housing13. Housin ...

BJ Boot Components and Components Location
Components 1. BJ assembly2. BJ circlip3. BJ boot band4. BJ boot5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band9. TJ boot10. Spider assembly11. Retainer ring12. TJ housing13. Housin ...

Other Information:

Rail Pressure Sensor (RPS) Description and Operation
Description Rail Pressure Sensor (RPS), installed on the delivery pipe, measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the s ...

Spark Plug Repair procedures
Inspection [On vehicle inspection] 1. Accelerate the engine to about 3,000 rpm 3 times or more. 2. Remove the spark plug. 3. Check the spark plug visually. If the electrode is dry, the ...

Categories

Copyright © www.kisedona.com 2016-2026