Kia Sedona: Line Pressure Control Solenoid Vale Specifications - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sedona YP Service ManualKia Sedona: Line Pressure Control Solenoid Vale Specifications

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Line Pressure Control Solenoid Vale Specifications

Specification
Item
Specification
Control type
N/H (Normal High)
Control pressure kpa (kgf/cm², psi)
500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)
Current value (mA)
50 ~ 850
Coil resistance(Ω)
5.1 ± 0.3

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Me ...

Line Pressure Control Solenoid Vale Components and Components Location
Component Location 1. Line pressure control solenoid valve (LINE_VFS) ...

Other Information:

Delivery Pipe Repair procedures
Removal     When removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, injury may be caused by leakage of high pressure fuel. For ...

Camshaft Position Sensor (CMPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal     • DO NOT remove the cam ...

Categories


Copyright © www.kisedona.com 2016-2025