Kia Sedona: 26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sedona YP Service ManualKia Sedona: 26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).

4.
Measure the resistance between power terminal (5) and signal terminal (11).

Specification : 5.1 ± 0.3 Ω

Replacement
   
If a solenoid valve of VFS type needs to be replaced, the valve body assembly should be replaced and the oil pressure should be adjusted. If the solenoid valve is replaced individually, it is not possible to adjust the oil pressure without additional equipment, and if the oil pressure adjustment procedure is not performed, a shift shock or delay may occur.
1.
Replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
26 Brake Control Solenoid Valve(26/B_VFS) Schematic Diagrams
Circuit Diagram ...

Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
Specification Item SpecificationControl typeN/H (Normal High)"Control pressure kpa (kgf/cm², psi)""500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)"Current value (mA)50 ~ 850Coil resistance(Ω)5.1 ± 0. ...

Other Information:

Good braking practices
Check to be sure the parking brake is not engaged and the parking brake indicator light is out before driving away. Driving through water may get the brakes wet. They can also get wet when ...

Muffler Components and Components Location
Components 1. Gasket2. Hanger3. Front muffler4. Catalytic converter & Center muffler assembly5. Rear muffler6. Tail muffler ...

Categories


Copyright © www.kisedona.com 2016-2025