Kia Sedona: Filler-Neck Assembly Repair procedures - Fuel Delivery System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Filler-Neck Assembly Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures

Removal
1.
Open the fuel filler door and then remove the filler-neck mounting bolts (A).

Filler-neck assembly mounting bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

2.
Left the vehice.
3.
Remove the rear-LH wheel, tire, and the inner wheel house (A).

4.
Disconnect the fuel filler hose (A).
5.
Disconnect the ventilation hose quick-connector (B).

6.
Remove the filler-neck assembly from the vehicle after removing the bracket mounting nut (A).

Installation
1.
Install in the reverse order of removal.
Fuel Pressure Regulator Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the fuel sender connector (A) and fuel pump connector (B). 3. Remove the cushion pipe fixi ...

Delivery Pipe Repair procedures
Removal     When removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, injury may be caused by leakage of high pressure fuel. For ...

Other Information:

Non-operational conditions of rear parking assist system
The rear parking assist system may not operate properly when : 1. Moisture is frozen to the sensor. (It will operate normally when the moisture has been cleared.) 2. The sensor is covered with for ...

Special Service Tools
Special Service Tools Tool Name / NumberIllustrationDescriptionFuel Pressure Gauge and hose09353-24100Used for measuring the pressure in fuel lineFuel Pressure Gauge Adapter09353-38000Used for co ...

Categories


Copyright © www.kisedona.com 2016-2024