Kia Sedona: Seat Belt Buckle Switch (BS) Repair procedures
1.
Disconnect the battery negative cable and wait for at least 30 seconds before beginning to work.
2.
Remove the front seat assembly.
(Refer to Body - "Front seat")
3.
Loosen the seat belt buckle mounting bolt and remove the seat belt buckle switch (A).
When installing the harness wires, be sure that they are not pinched or interfering with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least 30 seconds before beginning to work.
3.
Install the seat belt buckle switch.
Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)
4.
Install the front seat assembly.
(Refer to Body - "Front seat")
5.
Reconnect the battery negative cable.
6.
After installing the seat belt buckle switch, confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.
Description
In order to make normal activation of airbag system, SRSCM
detects DTC(s) for the Passive occupant detection system (PODS-F). If
the seat is occupied, PODS-F detects passenger prese ...
Other Information: Operating door locks from outside the vehicle
Turn the key clockwise to lock and counterclockwise to unlock.
If you lock the driver ...
Troubleshooting
Troubleshooting
Trouble SymptomProbable CauseRemedyEngine misfire with abnormal internal lower engine noises.Worn crankshaft bearings.Loose or damaged engine drive plate.Replace the crankshaft an ...