The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer.
HI : Continuous wipe
LO : Intermittent wipe
OFF : OFF
The rear window wiper is switched on automatically when the ignition is in OFF and the gear is shifted to R (Reverse) while the wiper is in motion.
The automatic rear wiper function can be turned on or off in 'User setting mode' on the cluster display.
Push the lever away from you to spray rear washer fluid and to run the rear wipers 1~3 cycles. The spray and wiper operation will continue until you release the lever
Troubleshooting
Troubleshooting
Customer Complaint Analysis Check Sheet
There are six areas where a problem can occur: wiring
harness, the radio, the CD player, and speaker. Troubleshooting enables
you to nar ...
General Information
Basic Service Symbols
There are five primary symbols used to complement
illustrations. These symbols indicate the part to apply such materials
during service.
SymbolMeaningDo not reuse the p ...