Kia Optima Manuals

Kia Sedona: Rear Hub - Carrier Repair procedures - Rear Axle Assembly - Driveshaft and axle - Kia Sedona YP Service ManualKia Sedona: Rear Hub - Carrier Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Driveshaft and axle / Rear Axle Assembly / Rear Hub - Carrier Repair procedures

Removal
1.
Remove the front wheel and tire (A) from front hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
   
Be careful not to damage the hub bolts when removing the front wheel and tire (A).

2.
Remove the bolt (A) and then remove the rear caliper assembly (B).
Tightening torque:
78.4 ~ 98.1 N.m (8.0 ~ 10.0 kgf.m, 57.8 ~ 72.1 lb-ft)

3.
Remove the screw (B) and then remove the rear brake disc.

4.
Remove the wheel speed sensor connector (A).

5.
Remove the hub assembly mounting bolt (B).
Tightening torque:
78.4 ~ 98.1 N.m (8.0 ~ 10.0 kgf.m, 57.8 ~ 72.1 lb-ft)

6.
Remove the hub assembly (A).

7.
Install in the reverse order of removal.
Rear Hub - Carrier Components and Components Location
Components 1. Rear carrier assembly2. Parking brake assembly3. Rear hub assembly4. Rear brake disc ...

Rear Axle Repair procedures
Removal 1. Remove the front wheel and tire (A) from front hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)     Be careful not to damag ...

Other Information:

Side curtain
To use the side curtain : 1. Lift the curtain by the handle (1). 2. Hang the curtain on the hooks on both sides of the handle. To avoid injury or damage to the side curtain and door moldings, l ...

ETC (Electronic Throttle Control) System Troubleshooting
Fail-Safe Mode ItemFail-SafeETC MotorThrottle valve stuck at 7°TPSTPS 1 faultECM looks at TPS2TPS 2 faultECM looks at TPS1TPS 1,2 faultThrottle valve stuck at 7°APSAPS 1 faultECM looks at APS 2 ...

Categories

Copyright © www.kisedona.com 2016-2026