Kia Sedona: Radiator Grill Repair procedures - Front Bumper - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Radiator Grill Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Front Bumper / Radiator Grill Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front bumper cover.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Disconnect the wiring fixing fastener (A).

3.
Remove the front bumper energy absorber (B).

4.
Loosen the screws and remove the radiator mesh (A).

5.
Loosen the screws and remove the radiator grill (A) from the front bumper.

6.
Loosen the screws and remove the radiator grill (A).

7.
Install in the reverse order of removal.
   
Replace any damaged clips.
Radiator Grill Components and Components Location
Component Location 1. Radiator grill ...

Rear Bumper
...

Other Information:

Closing the hood
1. Before closing the hood, check the following: All filler caps in the engine compartment must be correctly installed. Gloves, rags or any other combustible material must be removed from the ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Specifications
Specification Item SpecificationControl typeN/H (Normal High)Control pressure kpa (kgf/cm², psi)"500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)"Current value (mA)50 ~ 850Coil resistance(Ω)5.1 ± 0.3 ...

Categories


Copyright © www.kisedona.com 2016-2025