Kia Optima Manuals

Kia Sedona: Power Seat Motor Repair procedures - Seat Electrical - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Power Seat Motor Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Body Electrical System / Seat Electrical / Power Seat Motor Repair procedures

Inspection
Diagnosis With GDS
1.
The body electrical system can be quickly diagnosed for faulty parts using vehicle diagnostic system (GDS).
The diagnostic system (GDS) provides the following information:
(1)
Self diagnosis : Checking the failure code (DTC) and display
(2)
Current data : Checking the system input/output data state
(3)
Actuator test : Checking the system operation condition
(4)
Additional function : Other controlling such as he system option and zero point adjustment
2.
Select the ''Car model'' and the system to be checked in order to check the vehicle with the tester.
3.
Select the ''Power seat module (PSM)'' to check the power seat module (PSM).
4.
Select the ''Current Data" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the power seat module (PSM) can be checked.
5.
If you wish to check the power door lock operation by force, select "Actuation test".
Power Seat Motor
1.
Disconnect the connectors for each motor.
[Slide motor]

[Rear height motor]

[Front height motor]

[Reclining motor]

[Lumbar support motor]

2.
With the battery connected directly to the motor terminals, check if the motors run smoothly.
3.
Reverse the connections and check that the motor turns in reverse.
4.
If there is an abnormality, replace the motors.
[Driver / Assist]

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly")
Installation
1.
Install the front seat assembly.
2.
Connect the negative (-) battery terminal.
Components and Components Location
Component Location 1. Front tilt motor2. Slide motor3. Rear height motor4. Reclining motor5. Lumbar support motor (Vertical)6. Seat cushion switch7. Seat back switch8. Lumbar support switch ...

Power Seat Control Switch Schematic Diagrams
Circuit Diagram ...

Other Information:

Ventilation
1. Set the mode to the position. 2. Set the air intake control to the outside (fresh) air position. 3. Set the temperature control to the desired position. 4. Set the fan speed control to the desi ...

Luggage Side Trim Repair procedures
Replacement     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. ...

Categories


Copyright В© www.kisedona.com 2016-2025