Kia Sedona: Portable lamp usage - Interior lights - Features of your vehicle - Kia Sedona YP Owners ManualKia Sedona: Portable lamp usage

Third generation YP (2014-2024) / Kia Sedona YP Owners Manual / Features of your vehicle / Interior lights / Portable lamp usage

1. In-vehicle lamp, if necessary, after separation can be used as a portable.

2. Press push button (1).

3. Pull out the lamp holder.

4. Press the power switch (2).

❈ If the portable lamp does not turn on, it means the portable lamp needs to be charged. Insert the lamp holder and then charge it again. The charge mode will be activated if the ignition switch (or engine start/stop button) is on position or engine is running.

1. Remove the batteries when not in use for a long time.

2. Use the specified battery.

3.You can use the regular batteries (Disposable batteries) but do not use the Non-rechargeable battery in charge mode. It may damage the vehicle.

4. Do not place the lamp with water or moist places and liquid compounds. These can cause internal leakage of a battery.

5. When replacing the batteries, check the direction and insert. It will not be charged if installed reversely.

6. Do not mix the rechargeable batteries. It may not be charged normally.

7. Do not place the lamp or batteries near fire or heat. It can cause internal leakage of a battery.

8. Do not apply electrical shock with portable charging terminals of the lamp.

It can cause internal leakage of a battery or damage the portable lamp.

9. If the portable lamp does not turn on anymore after charged, replace the rechargeable batteries.

Vanity mirror lamp
Opening the lid of the vanity mirror will automatically turn on the mirror light. ...

Battery replacement
When replacement is necessary, use the following procedure. 1. Insert a slim tool into the slot and gently try open the battery cover. 2. Replace the batteries with new rechargeable batteries (AAA ...

Other Information:

Relay Box (Engine Compartment) Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Pull out the relay from the engine compartment relay block. Power Relay (Type A) Check for continuity between the terminals. ...

Power Steering Hoses Repair procedures
Removal 1. Drain the power steering fluid. 2. Remove the surge tank. (Refer to Engine Mechanical System - "Surge Tank") 3. Remove the center muffler (Refer to Engine Mechanical System - ...

Categories


Copyright В© www.kisedona.com 2016-2024