Parking assist system may not operate normally when :
1. Moisture is frozen to the sensor. (It will operate normally when moisture melts.)
2. Sensor is covered with foreign matter, such as snow or water, or the sensor cover is blocked. (It will operate normally when the material is removed or the sensor is no longer blocked.)
3. Sensor is stained with foreign matter such as snow or water. (Sensing range will return to normal when removed.)
4. The parking assist button is off.
There is a possibility of parking assist system malfunction when :
1. Driving on uneven road surfaces such as unpaved roads, gravel, bumps, or gradient.
2. Objects generating excessive noise such as vehicle horns, loud motorcycle engines, or truck air brakes can interfere with the sensor.
3. Heavy rain or water spray.
4. Wireless transmitters or mobile phones present near the sensor.
5. Sensor is covered with snow.
Detecting range may decrease when :
1. Outside air temperature is extremely hot or cold.
2. Undetectable objects smaller than 1 m (39 in) and narrower than 14 cm (5.5 in) in diameter.
The following objects may not be recognized by the sensor :
1. Sharp or slim objects such as ropes, chains or small poles.
2. Objects, which tend to absorb sensor frequency such as clothes, spongy material or snow.
✽ NOTICE
1. The warning may not sound sequentially depending on the speed and shapes
of the objects detected.
2. The parking assist system may malfunction if the vehicle bumper height or sensor
installation has been modified. Any non-factory installed equipment or accessories
may also interfere with the sensor performance.
3. Sensor may not recognize objects less than 30 cm (12 in) from the sensor, or
it may sense an incorrect distance. Use with caution.
4. When the sensor is frozen or stained with snow or water, the sensor may be inoperative
until the stains are removed using a soft cloth.
5. Do not push, scratch or strike the sensor with any hard objects that could damage
the surface of the sensor. Sensor damage could occur.
✽ NOTICE
This system can only sense objects within the range and location of the sensors, it can not detect objects in other areas where sensors are not installed. Also, small or slim objects, or objects located between sensors may not be detected.
Always visually check in front and behind the vehicle when driving. Be sure
to inform any drivers in the vehicle that may be unfamiliar with the system regarding
the system Noise and smoke Rear Seat Back Cover Components and Components Location
✽ NOTICE
The indicator may differ from the illustration as objects or sensors status.
If the indicator blinks, the system should be checked by an authorized Kia dealer. ...
Types of warning sound and indicator
If you don ...
Self-diagnosis
Other Information:
When inflated, the air bags make a loud noise and leave smoke and powder in the
air inside the vehicle. This is normal and is a result of the ignition of the air
bag inflator. After the air bag in ...
Component Location
[Second Row Seat Assembly]
1. Second Row Seat Back Cover [RH]2. Second Row Center Seat Back Cover3. Second Row Seat Back Cover [LH]
1. Second Row Seat Back Cover
...