Kia Sedona: Latch Switch Repair procedures
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Power Sliding Door System / Latch Switch Repair procedures
| Inspection |
| 1. |
When inspecting, use the inspection equipment to check for
input/output values at each position of Power Sliding Door control
module. |
| 2. |
To check the operation of latch, choose “Power Sliding/Tailgate” menu and vehicle. |
| 3. |
Select "Power Sliding Door". |
| 4. |
After selecting sensor output, operate the Power Sliding Door
in Power Mode and check the voltage of unlatch feedback (in closed
mode).
※ Actual voltage may differ from the above figure. |
| 5. |
When there’s no change in voltage, replace the latch. |
Power Sliding Door (PSD) Control Module Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the luggage side trim [LH].
(Refer to Body - "Luggage Side Trim")
3.
Disconnect the power sliding door control module co ...
Power Sliding Door (PSD) Switch Repair procedures
Inspection
Overhead Console Door Switch Inspection
1.
When inspecting, use the inspection equipment to check for
input/output values of Overhead console door switch. If there''s any
malfunct ...
Other Information:
Vehicle handling instructions
As with other vehicles of this type, failure to operate this vehicle correctly
may result in loss of control, an accident or vehicle rollover.
Specific design characteristics (higher ground clearan ...
Ignition switch position
LOCK
The steering wheel locks to protect against theft (if equipped). The ignition
key can be removed only in the LOCK position.
ACC (Accessory)
The steering wheel is unlocked and electrical ac ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026