Kia Sedona: Front Impact Sensor (FIS) Description and Operation - SRSCM - Restraint - Kia Sedona YP Service ManualKia Sedona: Front Impact Sensor (FIS) Description and Operation

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Description and Operation

Description
The Front Impact Sensors (FIS) are installed in the Front End Module (FEM). These remote sensors are used to detect acceleration due to a collision at the mounting location. The primary purpose of the Front Impact Sensor (FIS) is to provide an indication of a collision. The Front Impact Sensor (FIS) sends acceleration data to the SRSCM.
SRS Control Module (SRSCM) Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. 3. Remove the floor console. (Re ...

Front Impact Sensor (FIS) Components and Components Location
Components ...

Other Information:

Rear Oil Seal Repair procedures
Replacement 1. Remove the transaxle assembly. (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the drive plate. (Refer to Cylinder Block - "Drive Plate") 3. Remov ...

Troubleshooting
Failure Inspection Inspection and Test – Smart Tailgate System Smart Tailgate system is a complex system consists of many components. To get an accurate test and result, the control module o ...

Categories


Copyright В© www.kisedona.com 2016-2025