Kia Optima Manuals

Kia Sedona: Front Door Module Repair procedures - Front Door - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Front Door Module Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Front Door / Front Door Module Repair procedures

Replacement
1.
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass")
2.
Remove the front door outside handle.
(Refer to Front Door - "Front Door Outside Handle")
3.
Disconnect the front door main connector (A).

4.
Loosen the front door outside handle base mounting bolt (A).

5.
Disconnect the outside rear view mirror connector (A).

6.
Loosen the front door latch (B) mounting screws.
7.
After loosening the mounting bolts, remove the front door module (A).
Tightening torque :
Bolt : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Screw : 7.8 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m, 5.8 ~ 8.0 lb-ft)

8.
Disconnect the connectors and front door module wiring harness (A).

9.
Disconnect the front door latch connector (A).

10.
Remove the front door latch assembly.
(Refer to Front Door - "Front Door Latch")
11.
Remove the front speaker.
(Refer to Body Electrical System - "Speakers")
12.
Remove the front power window motor.
(Refer to Body Electrical System - "Power Window Motor")
13.
Install in the reverse order of removal.
   
•
Apply sufficient grease on all rolling friction parts and springs.
•
Make sure that connectors are connected properly and each rod is connected securely.
•
Make sure that the door locks/unlocks and opens/closes properly.
Front Door Module Components and Components Location
Component Location 1. Front door module ...

Front Door Outside Handle Components and Components Location
Component Location 1. Front door outside handle ...

Other Information:

Record your key number
The key code number is stamped on the bar code tag attached to the key set. Should you lose your keys, this number will enable an authorized Kia dealer to duplicate the keys easily. Remove the b ...

Spark Plug Repair procedures
Inspection [On vehicle inspection] 1. Accelerate the engine to about 3,000 rpm 3 times or more. 2. Remove the spark plug. 3. Check the spark plug visually. If the electrode is dry, the ...

Categories

Copyright © www.kisedona.com 2016-2026