Kia Sedona: ESC OFF Switch Repair procedures - ESC(Electronic Stability Control) System - Brake System - Kia Sedona YP Service ManualKia Sedona: ESC OFF Switch Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Brake System / ESC(Electronic Stability Control) System / ESC OFF Switch Repair procedures

Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
3.
Remove the crash pad side switch assembly (A).

4.
Check the continuity between the switch terminals as the ESC OFF switch is engaged.

ESC OFF Switch Description and Operation
Description 1. The ESP OFF switch is used by users to turn off the ESP system. 2. The ESP OFF lamp is on when ESP OFF switch is engaged. ...

Steering Angle Sensor Description and Operation
Description Installed in MDPS (Motor Driven Power Steering), the Steering Angle Sensor (SAS) sends signals to HECU through CAN communication line. The SAS is used to determine turning directio ...

Other Information:

Troubleshooting
Troubleshooting Limp Home Mode Features a fail-safe function that prevents dangerous situations in the event of a transaxle failure.The vehicle will be driven in limp home mode if the transa ...

Front Driveshaft Repair procedures
Removal 1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)     Be careful not to dam ...

Categories


Copyright В© www.kisedona.com 2016-2024