1. Turn the ignition switch and all other switches off.
2. Remove the fuse panel cover by pressing the tab and pulling the cover up.
When the blade type fuse is disconnected, remove it by using the clip designed for changing fuses located in the engine room fuse box. Upon removal, securely insert reserve fuse of equal quantity.
3. Check the removed fuse; replace it if it is blown. To remove or insert the fuse, use the fuse puller in the engine compartment fuse panel.
4. Push in a new fuse of the same rating, and make sure it fits tightly in the clips. If it fits loosely, consult an authorized Kia dealer.
CAUTION - Fuse panel covers
After checking the fuse panel in the engine compartment, securely install the fuse panel cover. If not, electrical failures may occur from water contact.
Main fuse
If the main fuse is blown, it must be removed as follows:
1. Turn off the engine.
2. Disconnect the negative battery cable.
3. Remove the nuts shown in the picture above.
4. Replace the fuse with a new one of the same rating.
5. Reinstall in the reverse order of removal.
Repair procedures
Removal
Put on gloves to protect your hands.
Use seat covers to avoid damaging any surfaces.
1.
Remove the front pillar trim.
(Re ...
Rear Door Side Weatherstrip Repair procedures
Replacement
1.
Remove the clips (C) and remove the rear door side weatherstrip (A).
Butyl tape (B) and mounting clips (C) securely seated.
2.
Install in the rev ...