Kia Sedona: Description and Operation - Back view camera System - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Description and Operation

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Back view camera System / Description and Operation

Description
Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.
This supplemental system shows the back of the vehicle on the monitor when the vehicle is backing up.
   
This system is a supplmentary function only. It is the responsibility of the driver to always check the back of the vehicle through inside and outside rearview mirrors or directly whenever the vehicle is backing up as there is a dead zone hidden from the camera.
Schematic Diagrams
Circuit Diagram ...

Repair procedures
Removal 1. Disconnect the negetive (-) battery terminal. 2. Remove the tailgate back panel. (Refer to Body - "Tailgate Back Panel") 3. Remove the back view camera (A) after loosening the ...

Other Information:

Rear window defroster
Manual type Automatic type The defroster heats the window to remove frost, fog and thin ice from the rear window, while the engine is running. To activate the rear window defroster, press the ...

Side Impact Sensor (SIS) Description and Operation
Description Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensors (P-SIS), installed at each center of front door modules (LH and RH), two SIS, installed at each center o ...

Categories

Copyright © www.kisedona.com 2016-2026