Kia Sedona: Crankshaft Position Sensor (CKPS) Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Crankshaft Position Sensor (CKPS) Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.

Specification: Refer to “Wave Form”

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
3.
Remove the battery tray.
(Refer to Engine Electrical System - "battery")
4.
Disconnect the crankshaft position sensor connector (A).
5.
Remove the mounting bolt (B), and then vertically remove the sensor from the transaxle housing.

Installation
   
•
Install the component to the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Apply the engine oil to the O-ring.
•
Insert the sensor in the installation hole and be careful not to damage sensor when installing.
1.
Install in the reverse order of removal.

Crankshaft position sensor installation bolt:
6.9 ~ 9.8 N.m (0.7 ~ 1.0 kgf.m, 5.1 ~ 7.2 lb-ft)

Crankshaft Position Sensor (CKPS) Schematic Diagrams
Circuit Diagram ...

Crankshaft Position Sensor (CKPS) Troubleshooting
Wave Form ...

Other Information:

AC Inverter Unit Components and Components Location
Components ...

Operating conditions
Type B Type C Select RCTA (Rear Cross Traffic Alert) in "User Settings" under "Driving Assist" on the instrument cluster. The system will turn on and standby to activat ...

Categories

Copyright © www.kisedona.com 2016-2026